|
Post by vsljames on Apr 13, 2017 15:32:50 GMT
Has anyone else had issues with Preset Manager after updating to 4.2? So far I've noticed: - When recording over an existing preset, "Replace" just deletes the existing preset
- When recording a new preset the playhead must be paused and layer level must be at full, even with record level not selected. If the layer isn't paused when recorded then it will automatically start to play when the preset is selected, even if the level of the layer is at 0.
|
|
Alex
Staff
Posts: 24
|
Post by Alex on Apr 18, 2017 11:38:36 GMT
Hi vsljames,
I can verify that both bugs exist in 4.2 rev26569 but have already been fixed. They will be with you in the next release. Regarding the second bug bear in mind that the Source Preset saves the pin values for MediaPlayer. A simple example is with the Pause on Dark button. If you record a Source only Preset with Pause on dark enabled then it all lies to the layer level when you record the Preset. a. If the layer level is non zero when recording the preset then the Preset will only play the clip if the layer level is non zero. It will not play on zero level because of the Pause on dark which is enabled. b. If the layer level is zero when recording the preset the clip will be paused because of Pause on dark so the preset will always bring the clip paused regardless of the layer level. I hope this helps.
Alex
|
|