Post by Ned on Feb 18, 2017 16:01:34 GMT
EleCard SDI Capture Card Stopping the Engine 3.2 - Patch
Posted by Ryan Brown on 14 January 2014 03:55 PM
Summary:
EleCard SDI Capture Cards can cause the engine to stop rendering in Version 3.2.
This sometimes occurs when a layer is switched to capture as a source, and EleCard is selected.
If this happens, a red 'X' will appear over the engine icon in HippoNet Overview.
Solution:
Make sure that the EleCard drivers are completely installed.
These can be found on the Hippotizer: C:/HippotizerV3/Thirdparty/Elecard Drivers
Please follow the instructions contained in "usefullstuff toknow.txt".
Please download and install the attached patch.
More Information:
This is not an issue in 3.2.1 or earlier versions of Hippotizer.
Applies to software versions
3.2
Applies to hardware versions
Hippotizer HD's, Hippotizer Genlock HD's, GrassHoppers
elecard red x patch.zip (41.49 KB)
Posted by Ryan Brown on 14 January 2014 03:55 PM
Summary:
EleCard SDI Capture Cards can cause the engine to stop rendering in Version 3.2.
This sometimes occurs when a layer is switched to capture as a source, and EleCard is selected.
If this happens, a red 'X' will appear over the engine icon in HippoNet Overview.
Solution:
Make sure that the EleCard drivers are completely installed.
These can be found on the Hippotizer: C:/HippotizerV3/Thirdparty/Elecard Drivers
Please follow the instructions contained in "usefullstuff toknow.txt".
Please download and install the attached patch.
More Information:
This is not an issue in 3.2.1 or earlier versions of Hippotizer.
Applies to software versions
3.2
Applies to hardware versions
Hippotizer HD's, Hippotizer Genlock HD's, GrassHoppers
elecard red x patch.zip (41.49 KB)