CITP with Hippotizer and Avolites Jan 31, 2017 11:51:07 GMT Jonathan Pask likes this Quote Select PostDeselect PostLink to PostBack to Top Post by Suzy on Jan 31, 2017 11:51:07 GMT This was sent to me by one of our users to connect a Hippotizer V4.2 with a Avolites Tiger Touch 2 running Titan 10. 1. Start Hippo and Avo but leave network cable disconnected. 2. On the Avo I have been configuring my IP address and setting up broadcast artnet at this point. 3. On Hippo I have been configuring my mixes and layers to the required setup.4. Then I have been adding the DMX2 component after the engine has finished configuring.5. Then I have set up my DMX patch using the auto patch function.6. Next I added the CITP component and configured it to send on the right IP address and adapter. 7. I connected the hippo and avo to the network. (this occasionally results in a Zookeeper crash but after simply relaunching zookeeper this works fine.)8. On the Avo I would then go into the command prompt and open up the services window to restart the CITP service. 9. Then I would go to patch > Active fixtures > (select my device from the list) > then simply tap a free fixture space on the screen and it will patch all the layers.